Trinabess Power Box Installation Manual page 51

ID05 BatOVP
ID09 HW_LLCBus_OVP
ID10 HW_Boost_OVP
ID11 HwBuckBoostOCP
ID12 HwBatOCP
ID15 HwAcOCP
ID17 HwADFaultIGrid
The PowerCube
voltage is too high
LLCBus voltage is too
high and has triggered
hardware protection
Boost voltage is too high
and has triggered
hardware protection
BuckBoost current is too
high and has triggered
hardware protection
The PowerCube
current is too high and
has triggered hardware
protection
The grid current is too
high and has triggered
hardware protection
The grid current
sampling error
under-voltage,
over-frequency,
under-frequency
protection points
obtaining approval from
the local electrical grid
operator.
If the alarm
occasionally, the possible
cause is
process of charging.
If the alarm
occasionally,
2.0
whether the overvoltage
setting of the PowerCube
2.0 consistent with the
parameter
PowerCube
manufacturer
contact
support.
ID09- ID26 are
faults of the POWER BOX,
turn OFF the "DC & AC
switch", wait for 5 minutes,
then turn ON the "DC
switch" and turn ON the
"AC switch".
whether the
rectified. If
contact
support.
2.0
after
occurs
during the
occurs
check
of the
2.0
and
technical
internal
Check
fault is
no, please
technical