Power Supply Modules - Siemens SIMATIC S7-300 Reference Manual

Dimension Drawings
Introduction
In this appendix you will find the dimension drawings for the most important
components of an S7-300. The specifications in these dimension drawings are
required for dimensioning the S7-300 configuration. The dimensions of an S7-300
configuration must be taken into account when installing an S7-300 in cabinets,
switchgear rooms, etc. This appendix does not contain any dimension drawings of
the CPUs of the S7-300 or M7-300 or of the IM 153-1. These dimension drawings
are contained in the relevant manuals.
Contents
In this appendix, you will find the dimension drawings of the following S7-300
components.
Section
C.1
C.2
C.3
C.4
C.5
Programmable Logic Controllers S7-300 Module Data
A5E00105505-03
Dimension Drawings of the Rails
Dimension Drawings of the Power Supply Modules
Dimension Drawings of the Interface Modules
Dimension Drawings of the Signal Modules
Dimension Drawings for Accessories
Contents
C
Page
C-2
C-8
C-13
C-13
C-15
C-1