A-30 Parameters Of The Sm 332; Ao 8 X 12 Bits - Siemens SIMATIC S7-300 Reference Manual

A.10 Parameters of the SM 332; AO 8 x 12 bits
Parameters
Table A-28 contains all the parameters that you can set for the analog output
module SM 332; AO 8 x 12 bits. The comparison shows:
• Which parameters you can change with STEP 7 and
• Which parameters you can change with SFC 55 "WR_PARM".
The parameters which you set with STEP 7 can also be transferred to the module
with SFCs 56 and 57.
Table A-30 Parameters of the SM 332; AO 8 x 12 bits.
Diagnostics: Group diagnostics
Diagnostics interrupt enable
Behavior on CPU STOP
Output type
Output Range
Note
If you want to enable the diagnostic interrupt in the user program in data record 1,
you must enable the diagnosis in data record 0 beforehand using STEP 7.
Programmable Logic Controllers S7-300 Module Data
A5E00105505-03
Parameter
Parameter Sets for Signal Modules
Data Record Parameters can be assigned
No.
... SFC 55
0 No
Yes
Yes
1 1
Yes
Yes
with ...
...
Programming
Device
Yes
Yes
Yes
Yes
Yes
A-39