Cr/Csr Settings; Displaying Vme Settings - Motorola MVME5500 Installation And Use Manual

MOTLoad Firmware
3

CR/CSR Settings

Displaying VME Settings

3-16
The following sections provide additional information pertaining to the
VME firmware settings of the MVME5500. A few VME settings are
controlled by hardware jumpers while the majority of the VME settings are
managed by the firmware command utility vmeCfg.
The firmware supports both Auto Slot ID and Geographical Addressing for
assigning the CR/CSR base address dependent on a hardware jumper
setting. See the VME64 Specification and the VME64 Extensions for
details. As a result, a 512K byte CR/CSR area can be accessed from the
VMEbus using the CR/CSR AM code.
To display the changeable VME setting, type the following at the firmware
prompt:
vmeCfg -s -m
Displays Master Enable state
vmeCfg -s -i(0 - 7)
Displays selected Inbound Window state
vmeCfg -s -o(0 - 7)
Displays selected Outbound Window state
vmeCfg -s -r184
Displays PCI Miscellaneous Register state
vmeCfg -s -r188
Displays Special PCI Target Image Register state
vmeCfg -s -r400
Displays Master Control Register state
vmeCfg -s -r404
Displays Miscellaneous Control Register state
Literature Center Web Site