Configuration Of Inputs And Outputs; Erc 113 Inputs And Outputs; Possible Input And Output Connections - Danfoss ERC 113 Reference Manual

User manual

Configuration of inputs and outputs

ERC 113 inputs and outputs

Possible input and output
connections
Produced by Danfoss A/S (ADAP-KOOL®) | 2016-07
ERC 113 refrigeration controller
The ERC 113 inputs and outputs are configurable
by the customer. Before getting started it is a
good idea to check if all inputs are configured
correctly and match the sensors attached.
Input and output configuration settings are part
of the assignment menu "ASi".
NOTE: Coded sensors will impact on the number of
possible configurations
Inputs/outputs
Sensor 1
Sensor 2
Sensor 3
Sensor 4
Sensor 5
Sensor 7
Relay 2
Relay 3
Relay 4
Relay 5
DI (not com)
The table shows the possible input and output connections for the three application setups:
ERC 113 stand-alone, ERC 113 + remote display and ERC 113 + remote spindle.
For instance:
Danfoss supplies only 2-pole defrost sensors, so
input "S3" will most likely be used as a
defrost/evaporator temperature sensor input.
Please contact your local Danfoss representative
for information about default settings.
NOTE: remote display is always connected to the
digital input "Di" an d configured as "buS", whilst
remote spindle is always connected to "S3" and
configured as "rSp"
Stand-alone With remote display
X
X
X
X
X
X
X
X
DKRCC.ES.RL0.F5.02
With remote spindle
RDI 107 RSP 01
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
5