How To Replace Device - Siemens FC18 Operating Manual

30. HOW TO REPLACE DEVICE

Function: To copy the configuration information to the new equipment when the
old one is replaced.
Steps:
1. Press "Menu" to browse the main menu (Fig. 30-1)
Main menu displayed.
2. Press "→" to select "Browse" submenu (Fig. 30-2). Press "↓" to select "
Unconfigure" and then press "OK". Now the equipments unconfigure will be
displayed in the window (Fig.30-3).
3. Press "↓" to select equipment to configure. Press "→" to pop out the
shortcut menu (Fig.30-4). Use "↓" to select "Equipment Replacement" and
press "OK" to enter the equipment replacement interface.
4. Press "→" to pop out the pull-down menu (Figure 30-5), and all equipments
that can be replaced will be displayed. Press "↓"/" ↑" to choose
equipments that need to be replaced, and press "OK". System returns to
the original window.
But the save here is just temporary; if the equipment is restarted, the
change will be lost. For long-term storage, please refer to "how to save
configuration". If you don't want to save this change, press "Quit" to quit.
Note: The saved change will not take effect until the system is restarted.
Operating Manual of FC18 Controller
Fig.30-1
Fig.30-2
Fig.30-3
Fig.30-4
Fig.30-5
Page: 48/63