Fire Alarm Event Handling - Siemens FC18 Operating Manual

5.

FIRE ALARM EVENT HANDLING

Fire alarm status:
l Fire alarm indicator turns on
l Fire event with customer information shown in the LCD as the figure
l Acknowledge/Silence indicator flashing
l NAC activation indicator turns on
l Buzzer turns on
l NAC devices activated
How to handle:
1. Press Acknowledge/Silence to silence the buzzer:
l Under Level 1 interface, a login interface pops out automatically. Enter
Level 2/3 password and press "OK" to return back to fire alarm window
then press "Acknowledge/Silence". Now,
Buzzer is mute
－
The Acknowledge/Silence indicator turns off
－
－ NAC devices still in activation status
l Under Level 2/3 interface,
－ Buzzer is mute
－ The Acknowledge/Silence indicator turns off
－ NAC devices still in activation status
2. Press "NAC Activation" to deactivate NAC devices and the indicator turns
off. Press it again to reactivate NAC devices and the indicator turns on. So
on and so forth.
3. Find out fire location from LCD.
4. Go to the site to investigate the situation.
5. Call the firemen immediately if it's an emergency. If it's controllable, press
"Reset" after handling the fire to remove the fire alarm event and the fire
alarm indicator turns off.
Handling multi-fire alarm:
－ Information of multi-fire alarm is displayed.
－ The cursor stays on the first alarm. Other alarms are displayed
repeatedly in a reverse order.
Browsing each item by pressing "↓" / "↑"
－
Note: There are 2 kinds of fire alarms namely "auto alarm" and "manual
alarm".
Operating Manual of FC18 Controller
Fig. 5-1fire alarm interface
Page: 22/63