26. HOW TO ASSIGN GROUP/ FRT
Function: It's more convenient to edit logic with the concept of "Group". There
are four groups in the system: detection group, control output group, supervision
group and FRT group. See Appendix table 3 for details.
Steps:
1.
Press "Menu" to browse the main menu (Fig. 26-1)
Main menu displayed.
2.
Press "→" to select "Brow" submenu (Fig. 26-2). Select "All" and then press
"OK". Now the tree diagram will be displayed in the window (Fig.26-3).
Press "↓"/" ↑" to find out the equipment to be assigned to group.
3.
Press "→" to pop out a shortcut menu (Fig.26-3). Use "↓" to select "Assign
Group" or "Assign FRT"and press "OK" to enter the grouping interface
(Fig.26-4).
4.
Press "→" to popup pull-down menu of groups that can be assigned to,
choose expected group, press "OK", and system will save and return to the
original window. But the save here is just temporary; if the equipment is
reloaded, changed data will lost. As a result, for long-term storage, please
refer to "how to save configuration". If you don't want to save this change,
press "C".
Note: The saved changes take effect immediately.
These operations can only be applied to the selected controller.
Operating Manual of FC18 Controller
Fig.26-1
Fig.26-2
Fig.26-3
Fig.26-4
Page: 43/63