Panasonic FP-X0 L14R User Manual page 94

6.5.9 1:N Communication (General-purpose Serial Communication)
The FP-X0 and the external units are connected using an RS485 cable. Using the protocol that
-
matches the external units, the F159 (MTRN) instruction is used to send and receive data.
As for the FP-X0 L40MR and L60MR, connect to the COM port terminals (RS485).
-
System register settings
No. Name
No. 412 Selection of communication mode
No. 413 Communication format
No. 415 Baud rate
No. 416 COM port
Starting address for receive buffer
For L40MR and L60MR types
No. 417 COM port
Receive buffer capacity
For L40MR and L60MR types
No. 420 Tool port
Starting address for receive buffer
No. 421 Tool port
Receive buffer capacity
Note) Both the baud rate switches on the side of the unit and the systerm register No. 415 should be set
for the COM port.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Note)
Note)
Note)
Set Value
General-purpose serial communication
Char. bit: ...... 7 bits/8 bits
Parity: ..... None/Odd/Even
Stop bit: ............ 1 bit/2 bits
Terminator: ........ CR/CR+LF/None/ETX
Header: ............ STX not exist / STX exist
When using tool port: 2400 bps to 115200 bps
When using COM port: 19200 bps, 115200 bps
DT0 to DT8191 (Default: DT0)
0 to 2048 words (Default: 2048 words)
L14R/L30R: DT0 to DT2499 (Default: DT0)
L40R/L60R: DDT0 to DT8191 (Default: DT4096)
L14R/L30R: 0 to 128 words (Default: 128 words)
L40R/L60R: 0 to 2048 words (Default: 2048 words)