Service Processor Connector Pin-Outs; Manually Initializing The Storage System Software; Manually Setting Up The Storage System - HP 3PAR StoreServ 7000 Service Manual

Figure 24 Maintenance PC Connector Pinouts

Service Processor Connector Pin-outs

Use at the SP end of a standard Ethernet cable and in conjunction with the laptop connector (PN
180-0055-01) to allow serial connection to the SP.
DB9 (Female) RJ45
Pin 2–Pin 2 (orange)
Pin 3–Pin 3 (black)
Pin 5–Pin 5 (green)
Figure 25 Service Processor Connector Pinouts

Manually Initializing the Storage System Software

Use the following procedures to manually set up the storage system and SP when access to the
wizards is not available.
NOTE: You must physically connect a laptop to the SP to complete these procedures. See the
section "Connecting a Laptop to the SP" in the HP 3PAR StorServ 7000 Storage Installation Guide.

Manually Setting up the Storage System

The Out-of-the-Box (OOTB) script guides you through setting up and configuring the storage system
software:
1. Connect the PC to the controller node 0 through a serial cable and log in with user ID
console.
2. From the Console Menu, select option 1, Out of The Box Procedure.
3PAR Console Menu 1400293-1 3.1.2.xxx
1. Out Of The Box Procedure
2. Run ootb-stress-analyzer
32 Installing Storage Software Manually