HP 3PAR StoreServ 7000 Service Manual page 52

9. Press ENTER to accept the default gateway address, or type an alternate default gateway
address and press ENTER. The setup script suggests a default gateway address based on the
IP address you have supplied.
Please enter the IP address of a default gateway, or NONE [<static.IP.address.1>]:
<default.gateway.address>
10. Type yes and press ENTER.
Will this ethernet interface be used for inbound and/or
yes
1 1. Press ENTER or type yes and press ENTER.
SP Network Parameters
Will this SP be allowed to be remotely controlled (yes or no)? [yes]
system)
[enter]
12. Type m and press ENTER.
SP Network Parameters
Which media will be used for Remote Operations ( ethernet or modem )?
[enter]
13. Type the phone number, including area code, for the SP and press ENTER.
SP Network Parameters
Please enter the SP's local phone number, including area code, using only
the following characters: 0-9 ( ) - , Ex: (510)555-1212
<splocalnumber>
NOTE:
14. Type the prefix required when dialing out from the operating site, if any, and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the required prefixes when dialing out.
- Just hit enter for no prefix
52 Installing Storage Software Manually
outbound files transfers (yes or no) [no]?
Enter Control-C at any time to abort this process
(Replying 'yes' will allow Remote Operations sessions from a Connection
Enter Control-C at any time to abort this process
Enter 'e' or 'm' [modem]:
Enter Control-C at any time to abort this process
Any outside prefix is entered separately.
011 813 55 12123: