HP 3PAR StoreServ 7000 Service Manual page 48

via SSH and HTTP.
Do you wish to configure the SP firewall in permissive mode? [yes/no][yes]
yes
37. Press ENTER or type yes and press ENTER to verify the network information you have supplied.
Some items appear only when applicable so the screen content may differ according to the
setup options you have chosen.
SP Network Parameters - Confirmation
Is this data correct? (yes or no)? [yes]
yes
38. Answering no returns you to step 6.
NOTE:
the 3PAR Connection system.
39. Set the time zone for the operating site:
a. Select a country from the list, type the corresponding number, then press ENTER.
b. Select a continent or ocean, type the corresponding number, then press ENTER.
c. Select a country from the regional list, type the corresponding number, then press ENTER.
d. Select a time zone region, type the corresponding number, then press ENTER.
40. Verify the time zone setting is correct, then type 1 and press ENTER. Choosing option 2 restarts
the time zone configuration.
NOTE:
instructions on the screen for appending the command to make the time zone change
permanent.
48 Installing Storage Software Manually
Enter Control-C at any time to abort this process
The Host Name is:
- Domain name:
- Public IP address: <static.IP.address>
- Netmask:
- Gateway:
- Network Speed:
DNS system(s):
3PAR Secure Service Agent transport control selected.
PERMISSIVE FIREWALL MODE SELECTED
NTP system address:
3PAR Secure Service Collector system
- Name/address:
- Proxy:
3PAR Secure Service Policy Manager
- Name/address:
- Port:
- Proxy:
The connection system IP and router number appear only when you are not using
The system automatically makes the time zone change permanent. Disregard the
<spname>
Company Name or IP Address
<subnet.mask.address>
<default.gateway.address>
AUTO
<static.IPv4.address>
none
Production
none
<static.IP.address>
8080
none