HP 3PAR StoreServ 7000 Service Manual page 42

30. Monitor the system while the SP uses the site key. When the system communications
configuration is complete, the following message appears:
*** starting final MOB phase
Updating PAM settings
Rebooting....
The SP automatically restarts.
Welcome to the 3PAR Service Processor Moment of Birth
Rebooting....
Continue to
Configuring the SP With Secure Network Mode
1. Connect the maintenance PC to the SP through serial connection, then power on the SP and
log in as the root user.
2. Press ENTER or type yes and press ENTER to begin the Service Processor Setup Wizard.
Welcome to the 3PAR Service Processor Moment of Birth
Are you ready to configure the SP at this time? (yes or no) [yes]:
[enter]
3. Press ENTER or type no and press ENTER.
Site Security Level
to access the public internet. Thus the SP public interface will be used only to
access and monitor the 3PAR InServ attached to this SP.
[enter]
CAUTION:
rebuild of the SP is required if the SP needs to establish communication link with HP Central.
4. Type 2 to assign Secure Network Mode for file transfer/remote operations.
Type of transport control
42 Installing Storage Software Manually
Fix passwords
Enabling key change on reboot ...
Disabling sendmail...
verifying postfix status...
Setup to run all ST/SP tasks at boot time
Add SPID to ppp id
Cleanup MOB
"Installing HP 3PAR OS Files " (page
Enter Control-C at any time to abort this process
Enter Control-C at any time to abort this process
A Secure Site is a site where the customer will NEVER allow a 3PAR SP
Is this a Secure Site? ( yes or no ) [no]
If you answer yes, the SP is not able to communicate with HP Central. A complete
Enter Control-C at any time to abort this process
61).