HP 3PAR StoreServ 7000 Service Manual page 53

- Number to get an outside line (ex. 8 or 9)
- Sequence to disable call waiting (ex. #70)
- When more then one sequence is required you may
have to insert one,
<prefix>
15. To use the 3PAR Connection system, press ENTER or type yes and press ENTER, and then skip
to step 19.
To specify an alternate connection system, type no, press ENTER, and continue to step 16.
Will this SP use the 3PAR Connection system? ( yes or no ) [yes]
[enter]
16. If you answered no in step 15, type the host name for the alternative connection system and
press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the fully qualified hostname for the Connection system
(use only alpha numeric or . - _)
- or -
QUIT to abort
<system_name>
17. Type the connection system PPPD system IP address and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Enter the Connection system's dialup (PPPD) system IP address.
Select it to be in one of following private networks IP ranges.
Note: This adress MUST be the same as specified on the Connection system,
using the ModemConfig command.
10.0.0.0
172.16.0.0
192.168.0.0
<PPPD.system.IP.address>
18. Type the connection system phone numbers, including area code and press ENTER.
Please enter Connection system phone number(s), including area code,
using only the following characters: 0-9 ( ) - ,
Ex: 1-510-555-1212
If there are more than one(1) phone numbers then separate them with a
colon(:)
<phone_number>
--> 10.255.255.255
--> 172.31.255.255
--> 192.168.255.255
011 813 555 12123
Manually Setting up the Service Processor 53