Setting Up The Service Processor; Accessing The Service Processor Setup Wizard - HP 3PAR StoreServ 7200 2-node Manual

2 Setting Up the Service Processor

Use SmartStart wizard step 2, Set up systems, to set up the Service Processor and the HP 3PAR
StoreServ Storage system. You need to set up the Service Processor and the storage system only
once for each new HP 3PAR storage system.
NOTE: After you have completed Service Processor setup, the Service Processor Setup wizard
does not allow you to re-enter the wizard. To modify Service Processor settings, use Service Processor
Onsite Customer Care (SPOCC).
You must set up the Service Processor before you can set up the HP 3PAR StoreServ Storage system.
The Service Processor enables you to perform administrative and diagnostic tasks.
To set up and configure the Service Processor:
1. Verify that the Service Processor is on.
2. Click the Set up the Service Processor link in SmartStart wizard step 2, Set up systems.

Accessing the Service Processor Setup Wizard

1. In the IP Address field, do one of the following:
If you are setting up a virtual Service Processor (VSP), enter the temporary IP address for
this VSP.
If you are setting up a physical Service Processor, enter the permanent IP address you
assigned in the Service Processor IP Setup wizard.
Accessing the Service Processor Setup Wizard 13