HP 3PAR StoreServ 7000 Service Manual page 51

4. Type 1 to assign SP Mode option for file transfer/remote operations and press ENTER.
Type of transport control
Enter Control-C at any time to abort this process
You have two options for file transfer/remote operations:
1 ==> SP Mode where inbound/outbound access is via ssh session and control
is via the Customer Controlled Access (CCA) setting.
2 ==> Secure Network Mode where inbound/outbound access is via https and
is controlled by the 3PAR Secure Service Agent (SSAgent).
X None of the above. Cancel and Exit
Please enter your selection [X]:
1
NOTE: Secure Network Mode cannot be enabled through Mixed Connectivity setup.
5. Type 1 and press ENTER to continue with this new installation.
Type of install
Enter Control-C at any time to abort this process
How do you want to configure this SP?
1 ==>
2 ==>
X None of the above. Cancel and Exit
1
6. Accept the default SP name (in brackets) by pressing ENTER or type an alternate name and
press ENTER. The default SP name is the SP serial number. HP recommends that you use the
default SP name.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the host name [SPXXXXX]: [enter]
7. Type the static IP address assigned to the SP and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for the public network interface:
<static.IP.address>
8. Press ENTER to accept the default subnet mask, or type an alternate subnet mask for the SP
and press ENTER.
Please enter the netmask for this interface [255.255.255.0]:
<subnet.mask.address>
Continue with spmob ( new site install )
Restore from a backup file ( SP rebuild/replacement )
Manually Setting up the Service Processor 51