Service Processor Connector Pin-Outs; Manually Initializing The Storage System Software; Manually Setting Up The Storage System - HP 3PAR StoreServ 7200 2-node Service Manual
Hp 3par storeserv 7000 storage service guide (qr482-96503, september 2013)
Hide thumbs
Also See for 3PAR StoreServ 7200 2-node:
- Administrator's manual (204 pages) ,
- Manual (107 pages) ,
- Installation and setup manual (35 pages)
Table of Contents
Advertisement
Figure 44 Maintenance PC Connector Pin-outs
Service Processor Connector Pin-outs
Use at the SP end of a standard Ethernet cable and in conjunction with the laptop adapter (PN
180-0055-01) to allow serial connection to the SP.
DB9 (Female) RJ45
Pin 2-Pin 3 (orange)
Pin 3-Pin 2 (black)
Pin 5-Pin 5 (green)
Figure 45 Service Processor Connector Pin-outs
Manually Initializing the Storage System Software
Use the following procedures to manually set up the storage system and SP when access to the
wizards is not available.
NOTE:
You must physically connect a laptop to the SP to complete these procedures. See the
section "Connecting a Laptop to the SP" in the HP 3PAR StoreServ 7000 Storage Installation Guide.
Manually Setting up the Storage System
The Out-of-the-Box (OOTB) script guides you through setting up and configuring the storage system
software:
1.
Connect the PC to the controller node 0 through a serial cable and log in with user ID
console.
2.
From the Console Menu, select option 1, Out of The Box Procedure.
3PAR Console Menu 1400293-1 3.1.2.xxx
1. Out Of The Box Procedure
2. Run ootb-stress-analyzer
3. Re-enter network configuration
4. Update the CBIOS
5. Enable or disable CLI error injections
6. Perform an IDE rescue
Manually Initializing the Storage System Software
45
Hide quick links:
Advertisement
Table of Contents
