Replacing Batteries In The Wireless Controller; Fcc And Industry Canada Information To User - Air Lift WirelessONE 25870 User Manual

REPLACING BATTERIES IN THE WIRELESS CONTROLLER

1. To install the two CR2032 batteries in the wireless
controller, use a small flat screwdriver
to separate the two halves of the controller by
prying apart the internal clip locations.
2. Stack the batteries positive to negative inside the

FCC AND INDUSTRY CANADA INFORMATION TO USER

This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Note: Changes or modifications not expressively approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Remote
FCC ID: 2ANLC-OMQ22817
20
Internal clips
IC: 23130-OMQ22817
Positive side
rear cover with the positive end pointed in the
direction of the circuit board. Take note of "NEG"
on the case and "+" symbol on the circuit board.
3. Snap the front cover/circuit board onto the rear
cover.
Manifold
FCC ID: 2ANLC-HJL71117
WirelessONE User Guide
Negative
side
IC: 23130-HJL71117