How To Remove And Install The Batteries In The Remote Contrtol Unit - Air Lift WirelessONE 25870 Installation Manual

WirelessONE
"T-Fitting" to Springs:
HOW TO REMOVE AND INSTALL THE BATTERIES IN THE
REMOTE CONTROL UNIT
1. To remove the two CR2032 batteries use a small flat screw driver to seperate the two
2. Stack the two CR2032 batteries Positive to Negative inside the rear cover.
3. Clip the front cover and circuit board into the rear cover (fig. 8).
MN-751
1. Cut a section of the 1/4" DOT air line (D) provided to go from "T-Fitting" (F) to Left
and Right air springs.
2. Insert one side of air line (D) into "T-Fitting" (F) and the other into the air springs.
halves of the key fob by prying at the internal clip locations shown in figure 7.
Internal Clips
M2
This is the
negative side
for battery
replacement .
M1
The case must be
aligned (as shown)
when assembling
with batteries .
fig. 8
Internal Clips
fig. 7
9