Installation; Quick Start Settings - Raven CR7 Operation Manual

INSTALLATION

1. Mount the antenna on the centerline of the tallest point of the vehicle (usually on
the top of the vehicle cabin) using the magnetic mount. Make sure that the
antenna has a clear, 360° view of the sky. If the mounting location is not metallic,
use a mounting plate to mount the antenna.
2. Route the Power/GPS cable to the back of the CRX console and connect it to the
Power/GPS port.
3. Use the provided RAM mount arm to install the CRX inside the cab.
4. For additional cabling and connection assistance, refer to the CRX Installation
Quick Guide. Additional system diagrams are available on the Raven web site.

QUICK START SETTINGS

When starting the CRX for the first time a setup wizard will walk you through a setup
process and, if desired, allow you to quickly start creating guidance lines. This section
covers the first time startup.
IMPORTANT: Enter all measurements as accurately as possible to ensure fewer issues with
field operations. Verify all measurements before entering them into the CRX
and ensure you enter the numbers correctly.
IMPORTANT: If configuring a CR12, the startup wizard will ask for the cable harness type.
The default cable harness is 117-8000-064 is the European cable. If using a
different cable, select that cable from the drop-down. The cable selection can
be edited later in the GPS Information tab if needed.
12
http://portal.ravenprecision.com/