Important Installation Safety Information - Raven Viper 4 Installation Manual

CHAPTER
1
Electrical Safety
While installing the Raven Viper
•
Disconnect the ROS device and all electrical components of the Raven system before jump-starting the
vehicle or welding on any component of the equipment.
•
Always verify that the power leads are connected to the correct polarity as marked. Reversing the power
leads could cause severe damage to the equipment.
•
To ensure that any system components are not activated automatically while installing system components,
install power cables, leads or connectors last.
Hydraulic Safety
While installing any hydraulic system components with the Viper 4 or 4+:
•
Wear appropriate protective equipment at all times when working on any hydraulic system.
•
Ensure the ROS device is disabled prior to starting any maintenance work on the machine or components
of the control system.
•
Never attempt to open or work on a hydraulic system with the equipment running. Care should always be
taken when opening a system that has been previously pressurized.
•
Use caution when disconnecting the hydraulic hoses or purging is required, be aware that the hydraulic fluid
may be extremely hot and under high pressure.
•
Any work performed on a hydraulic system must be done in accordance with the machine manufacturer's
approved maintenance instructions.
•
When installing hydraulics or performing diagnostics, maintenance or routine service, take precautions to
prevent any foreign material or contaminants from being introduced into the machine's hydraulic system.
Objects or materials that are able to bypass the machine's hydraulic filtration system will reduce
performance and possibly damage the hydraulic valves.
Manual No. 016-0171-559 Rev. C
I mportant Installation
C h a p t e r 1
Safety Information
CAUTION
®
4 or 4+ and other electrical system components:
1