Important Safety Information - Mira elite 2 Installation, Operation, Maintenance Manual

Section
1
2
1. Warning!
1.1. Products manufactured by us are safe and without risk provided they are
installed, used and maintained in good working order in accordance with our
instructions and recommendations.
1.2. THIS MIRA ELITE 2 MUST BE EARTHED.
In accordance with the current edition of 'The Plugs and Sockets etc. (Safety)
Regulations' in force at the time of installation, this Mira Elite is intended to be
permanently connected to the fixed electrical wiring of the mains system.
1.3. DO NOT twist the individual cable cores of the live and neutral conductors, as
this will prevent them from entering the terminal block.
1.4. DO NOT connect the Elite 2 to a mains-fed water supply. Such a connection will
damage the appliance, and is not covered under the manufacturer's guarantee.
1.5. DO NOT allow the Elite 2 to be run dry. We would recommend a minimum
25 gallon/113 ltr cold storage tank for water supply.
1.6. The shower unit must not be fitted where it may be exposed to freezing
conditions. Make sure that any pipework that could become frozen is properly
insulated.
1.7. DO NOT operate the appliance if it is frozen. Allow the appliance to thaw before
using again.
1.8. DO NOT operate this appliance if water leaks from the pressure relief valve,
maintenance will be required before the appliance can be safely used.
1.9. DO NOT fit any form of outlet flow control as the outlet acts as a vent for the tank
body. Only Mira recommended outlet fittings should be used.
1.10. There are no user serviceable components beneath the cover of this appliance.
Only a competent tradesperson should remove the cover.
1.11. If any of the following conditions occur, isolate the electricity and water supplies
and refer to "To contact us", on the back page of this guide.
1.11.1. If the cover is not correctly fitted and water has entered the Mira
Elite 2 case.
1.11.2. If the case is damaged.
4

Important Safety Information