Mira elite 2 Installation, Operation, Maintenance Manual page 5

1.11.3. If the appliance begins to make an odd noise, smell or smoke.
1.11.4. If the appliance shows signs of a distinct change in performance,
indicating a need for maintenance.
1.11.5. If the appliance is frozen.
1.12. Isolate the electrical and water supply before removing the cover.
1.13. Mains connections are exposed when the cover is removed.
1.14. Refer to the wiring diagram before making any electrical connections.
1.15. Ensure all electrical connections are tight, to prevent overheating.
2. Caution!
2.1. Read all of these instructions and retain this guide for later use.
2.2. Pass on this guide in the event of change of ownership of the installation site.
2.3. Follow all warnings, cautions and instructions contained in this guide, and on or
inside the Mira Sport.
2.4. The electrical installation must comply with the "Requirements for Electrical
Installations" commonly referred to as the IEE Wiring Regulations, or any
particular regulations and practices, specified by the local electricity supply
company in force at the time of installation. The installation should be carried out
by an electrician or contractor who is registered, or is a member of, an association
such as:
2.4.1. National Inspection Council for Electrical Installation and Contracting.
2.4.2. The Electrical Contractors Association (ECA), England and Wales.
2.4.3. The Electrical Contractors Association of Scotland (ECAS).
2.5. This is a high power unit; it is essential to contact your electricity supply
company to ensure that the electricity supply is adequate for the purpose.
2.6. The plumbing installation must comply with the requirements of UK Water
Regulations/Byelaws (Scotland), Building Regulations or any particular regulations
and practices, specified by the local water company or water undertakers. The
installation should be carried out by a plumber or contractor who is registered, or
is a member of, an association such as:
5