Fault Diagnosis - Mira elite 2 Installation, Operation, Maintenance Manual

Section
11

Fault Diagnosis

Warning! There are no user serviceable components beneath the cover of the Elite 2.
Only a competent tradesperson should remove the cover.
The trouble shooting information tabled below gives details on what you can do as a user
without removing the cover, should you encounter difficulties whilst operating the
shower.
Note! Should these remedies prove to be unsuccessful in solving your problem, contact
your installer for advice.
Malfunction
Elite 2 fails to operate
in any switch position.
No water or very low
flow rate.
26
Fault Diagnosis
Cause
Electrical supply isolated
at double pole switch ( the
pullcord).
Fuse blown or MCB/RCD
tripped indicating possible
electrical fault.
Handset sprayplate
blocked.
Incoming water supply
stop valves or isolating
valve turned down or off.
Hose or Handset blocked.
Possible blocked inlet filter Clean or replace.
Remedy
Switch on electrical supply via
the pullcord.
Renew the fuse or reset the
MCB/RCD. If fault persists,
contact your installer.
Remove & clean: Refer to
Maintenance in the I, O & M
guide for the fittings.
Turn stop/isolating valve to
fully on position.
Clear blockage or renew.
(Continued)