Mira elite 2 Installation, Operation, Maintenance Manual page 19

Important! Do not fit the Mira Elite 2 to the wall and tile up to the case. The Mira Elite 2 must be
fitted on to a finished flat and even wall surface (small pillars moulded on to the back of the case
allow air circulation).
Rubber feet
can be fitted
to the rear of
the case if
required.
Dust Shield
(Do not operate
the shower if the
dust shield is not
fitted.)
Terminal
Block
Electrical
Supply Cable
Inlet Connector
Assembly
(The inlet connector
assembly can be
swivelled to suit the
supply)
Cistern Fed Cold Water
Supply Pipe
Installation of the Mira Elite 2
Captive Cover Retaining
Screws
Fixing Screw
Service Tunnel
Fixing Screw
Drip Shield
(Do not operate
the shower if the
drip shield is not
fitted.)
Fixing Screw
19