Specifications - Mira elite 2 Installation, Operation, Maintenance Manual

Section
6
1. Plumbing
1.1. The 15 mm inlet compression connector incorporates an inlet filter, which
swivels to allow two entry positions, top and back.
1.2. The outlet terminates with a 1/2" BSP male thread for connection to a Mira
flexible shower hose.
2. Electrical
2.1. The terminal block will not accept cable larger than 16 mm
2.3. The motor is fitted with a self resetting thermal trip protection device,
designed to operate if the ambient temperatures become too high. The
maximum recommended ambient temperature for the Elite 2 is 30°C.
2.4. The following power ratings for the heater tanks are available with their
respective voltages:
2.5. The motor will absorb approximately 100 Watts maximum power under
normal working conditions.
3. Standards and Approvals
3.1. The Mira Elite 2 has been designed to comply with the requirements of the
British Electrotechnical Approvals Board (BEAB) and the requirements of UK
Water Regulations/Bylaws (Scotland).
3.2. This Mira Elite 2 complies with all relevant directives for CE marking.
10

Specifications

Mira Elite 2 9.8 @ 240V 45 Amps
Mira Elite 2 9.0 @ 230V 40 Amps
2 .