SMC Networks SMCWEB-N2 User Manual page 96

SMCWEB-N2 Wireless N Universal Repeater User Manual
Step 2 Click Add to specify a service for blocking. The Block Services Setup
page is displayed:
Step 3 Set the parameters in this page.
Service Type: Select a service type. If your desired type is not in the list,

select User defined. Then, you need to select the protocol, enter the service
name, and specify the port range. For services that exist in the drop-down list,
the corresponding information is already preset.
Protocol: Set the protocol used at service ports. If you are not sure about the

protocol that the application uses, select TCP/UDP.
Starting Port/Ending Port: The starting and ending ports of the port range

where the specified service is blocked. If the application uses a single port
number, enter the number in both fields.
Service Type/User Defined: Enter the service name.

Filter Service For: You can block the specified service for a single computer,

computers within an IP address range, or all computers.
After finishing settings, click Add to add a new rule. Then, click Apply to save the
settings.
- 96 -