Newport CONEX-PSD User Manual page 21

CONEX-PSD
Rel. Commands
1OF0.01221,0.01221,-0.02442,-0.01221
OF — Set/Get offset on ADC inputs 1 to 4
Usage Ready

Syntax xxOFnn,nn,nn,nn or xxOF?
Parameters
Description xx [int]
Range xx
nn [float] —
Units xx
nn
Defaults xx
Missing:
Out of range:
Floating point:
Description This command is only available with the Ge sensor. In CONFIGURATION state, this
command will set the offset for the ADC input 1 to 4.
Errors A
B
D
ZT
Example
Config.

— Controller address.
— 1 to 31
> -1 and < 1
— None
— None
Error B.
Error B.
Error A.
— Unknown message code or floating point controller address.
— Controller address not correct.
— Controller address not correct.
— Get all parameters.
|
Sets the ADC input offset of controller #1.
13
Two-Axis Position & Power Sensing Device
EDH0315En1030 — 07/16