Table of Contents
Advertisement
Chapter 1 Getting Started
Exploring the bottom panel
Exploring the bottom panel
Powering ON your unit
Powering OFF your unit
10
The SmartClass AC adapter and USB device ports are located on the bottom
panel. The USB device port is used to establish connections that allow you to
run reports from a remote device (typically a PC or laptop) or update the soft-
ware using the Download Manager utility.
AC adapter port
Figure 4 SmartClass bottom panel
The following procedure describes how to power ON the E1 Tester.
To power ON your unit
– Press and hold the Power key for a few seconds.
The SmartClass E1 splash screen appears for a few seconds, and then the
Main Menu appears.
The following procedure describes how to power OFF the E1 Tester.
To power OFF your unit
1 Press and hold the Power key for a few seconds.
The Power Control menu appears.
2 Do one of the following:
– If you want to be able to restart the unit quickly, select Enter Sleep
Mode. The test stops, and then the user interface disappears. If the
backlight is ON, the unit automatically turns it OFF. When you are
ready to resume testing, press the Power key for a few seconds to
redisplay the user interface.
NOTE: If your unit is in sleep mode for more than two hours, it will auto-
matically turn itself OFF.
SmartClass E1 Tester User's Guide
USB device port
Advertisement
Table of Contents
