Table of Contents
Advertisement
Preparation for use
General preparation
Table 5
SmartClass E1 Tester optional accessories (Continued)
Catalog Number
CB-0045402
Datacom testing
CB-44391
CB-44346
CB-44385
CB-44348
CB-44389
CB-44341
CB-44388
CB-44347
CB-21128081
CB-21118474
To order accessories for your E1 Tester, contact JDSU Customer Care, your
JDSU TAC representative, or your local JDSU sales office. You can also
contact JDSU through the company web site, www.jdsu.com.
This section explains how to start using your E1 Tester.
When you unpack the E1 Tester, do the following:
– Inspect the tester for damage.
– If undamaged, save the box and packing materials in case you need to
ship the tester in the future.
Before using the E1 Tester for the first time, do the following:
– If you are using alkaline batteries, verify that your unit is OFF, and then
install fresh batteries in the tester.
– If you are using rechargeable batteries, verify that your unit is OFF, and
then install the batteries in the tester. Before testing, make sure the
batteries have been fully charged (see
page
104).
– Turn the unit ON (see
– When prompted, specify the type of battery you installed.
– Verify that your unit is operating properly by navigating through a few
menus.
SmartClass E1 Tester User's Guide
Accessory
External 2M Reference Clock cable
X.21 10 MHz DTE/DCE Emulate
X.21 Monitor
V.24 DTE/DCE Emulate
V.24 Monitor
V.35 DTE/DCE Emulate
V.35 Monitor
V.36 DTE/DCE Emulate
V.36 Monitor
68-pin MDR to DB-15 cable (DTE emulation, for inter-
face to network)
68-pin MDR to Bananas (for Co-directional, Contra-
directional and Centralized testing)
"Recharging the batteries" on
"Powering ON your unit" on page
Chapter 1 Getting Started
Preparation for use
10).
5
Advertisement
Table of Contents
