Vth Settings (Version 3.1) - Dahua Villa VTO Quick Start Manual

Click "OK".
3.

2.2.2 VTH Settings (Version 3.1)

For the first time, please initialize the password and bind Email. Password is used to enter
project setting interface, while Email is used to retrieve your password when you forget it.
Step 1 Power on the device.
The system displays "Welcome" and enters "Initialization" interface, as shown in Figure
2-11.
Enter "Password", "Confirm Pwd" and "Email".
Step 2
Step 3 Click [OK].
The system displays "Info Init" interface. Press
Select "System Config >Project Settings".
Step 4
The system pops up "Password" prompt box.
Step 5 Enter the password set during initialization, and click [OK].
Step 6 Click [Net Set].
The system displays "Net Set" interface, as shown in Figure 2-12.
 IP addresses of VTH and VTO shall be in the same network segment. Otherwise,
VTH will fail to obtain VTO info after configuration.
To obtain IP with DHCP, please ensure the connected router has DHCP function

and DHCP function has been enabled.
Figure 2-11
to turn it off.
19