Vto6000Cm And Vto6100C - Dahua Villa VTO Quick Start Manual

2.1.2 VTO6000CM and VTO6100C

 Before installing the bracket or flush mount box, cables in the wall shall be led through the
bracket or flush mount box.
 Try not to install VTO6100C onto an iron door directly. Otherwise, signals may be shielded
and card induction may be poor.
Step 1 Dismantle M3 screws at the bottom of VTO and take off the decorative cap.
Step 2 Connect cables. Please refer to "1.2.2 Rear Panel" for details.
Step 3 Fix the bare device onto 86 box with M4 screws. Screw holes are located in Points 3 as
shown in the figure.
Step 4 To strengthen product firmness, after 86 box is in place, tighten it with ST3.0 screws in
Points 6 as shown in the figure.
Step 5 Install the decorative cap onto the bare device, and fix it with M3 screws.
Figure 2-1
12