Table of Contents
Advertisement
C H A P T E R 8 : U S I N G A T A G R E A D E R
If you have a tag reader installed, then it will be possible to set and unset the alarm system
using a tag (the same tags can also be used to set/unset via the keypad prox).
There are two types of readers that can be used with the Alarm System - the Internal Tag Reader
(used for indoors only) and the External tag reader (used for both indoors and outdoors).
Tags for the readers need to be programmed through the 'Change Codes' function in the Master
Manager Menu (see page 19). The internal and external readers can be both assigned to
individual level sets, this will need to be set up by your engineer.
Enabling the readers to the alarm system will be done by your engineer.
To set/unset the system using the Internal Tag Reader, present a pre-programmed tag to
the tag symbol as shown.
The system will then set depending on the type of exit mode programmed (Final door, Timed or
Push to set)
To set/unset the system using the external Tag Reader, present a pre-programmed tag to
the centre of the prox.
The system will then arm depending on the type of exit mode programmed (Final door, Timed
or Push to set)
Page: 12
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Enforcer and is the answer not in the manual?
Questions and answers
White with red buttons Panic fob: control panel says low battery alarm on panic fob, but I've changed the battery but still getting the error message, I need the exact steps to clear the yellow triangle flashing fault apart???