Chapter 5: Setting The Alarm (Code/Tag) - Pyronix Enforcer User Manual

C H A P T E R 5 : S E T T I N G T H E A L A R M ( C O D E / T A G )
 Enter your user code.
Or
 Present a valid tag to the symbol
circled.
 Enter the level set you wish to set, and
press the I key.
 'Please wait arming wireless' will be
displayed.
 There are three different setting
methods your installer will instruct you
through which of these have been
designed into your system.
 Final Door: Leave the building and
make sure the exit door is closed
properly.
 Timed: Make sure you leave the
building before the timer shown on the
keypad expires.
 Push to set: Press the push to set
button installed by your engineer to
arm the system.
SETTING USING A WIRELESS KEYFOB
 To set via a keyfob. Press the
 The keyfob LED will start to flash
GREEN indicating that the system is
starting to set.
 'Please wait arming wireless' will be
displayed on the keypad and the
programmed area will begin to set.
 To 'quick set', press and hold the ARM
key a second time for 4 seconds.
 Once set, the keyfob LED will
illuminate RED indicating that the
system is now set.
key
Page: 9