Chapter 12: Advanced Functions; Chime Feature; Omitting Inputs; Keypad Hold Up - Pyronix Enforcer User Manual

C H A P T E R 1 2 : A D V A N C E D F U N C T I O N S

12.1 Chime Feature

The chime can be used for any input on
the system. This can be set up by your
engineer.
To enable the chime on the keypad, when
the time is displayed, press the c key,
and a 'c' will be displayed on the right
side of the keypad display. Press the c
key again to clear the chime feature.

12.2 Omitting Inputs

On occasion, a detector may need to be
isolated if a room is occupied.
Enter your user code
Press the I key
Select the inputs that need to be omitted
Press the A key
After 10 seconds the exit time continues
Note: Inputs have to be programmed as
'omittable' by your engineer for this
feature to operate.

12.3 Keypad Hold Up

If an emergency alarm is needed, press
and hold both the 1 and 7 keys.
A 'hold up' alarm will be generated.
Note: The Hold Up facility needs to be
enabled by your engineer (either silent or
full alarm)
2-Key HU and any duress codes
programmed on the system by your
engineer are not permitted to send a
signal to the Alarm Receiving Centre
under police regulations in England,
Wales or Northern Ireland
Please note that the keyfob can also be
programmed to support a hold up
alarm. Please discuss this with your
engineer.
Page: 16