Start-Up; Switching System To Programming Mode - Gira 1288 00 Operating Instructions Manual

Switching system to programming mode

The Gira door communication system is switched to program-
ming mode for start-up:
1. Press the "Systemprogr." button on the control device for
3 seconds.
3 The yellow LED next to the programming button flashes
(flash frequency: 1 Hz) after the button is pressed and indi-
cates the active programming mode.
The system is now in programming mode for approx.
7 minutes. Each time the start-up button is pressed on a door
or home station, the time is reset to 7 minutes.
LED indicators on BUS devices
The active programming mode is also signalled by the LED
of various BUS devices, such as the hands-free feature home
station, the Comfort home station with receiver or the sur-
face-mounted hands-free feature home station.
An overview of the LED indication is found on Page 39.
Exiting programming mode
1. Briefly press the "Systemprogr." button on the control
device to exit the programming mode.
3 The yellow LED goes out.
Start-up documentation
For documentation on the home stations assigned to the call
buttons, please see the table on Page 41.
There you enter the names/homes in the sequence in which
you will allocate the home stations later on.
19