Deleting Assignment Of The Door Opener - Gira 1288 00 Operating Instructions Manual

Deleting assignment of door opener
32
Door opener at video control device
To delete an existing assignment between the door opener
connected at the control device and the door station, proceed
as follows:
1. Press the "System prog." button on the control device for
3 seconds to start programming mode (see Page 19).
2. Press the "Türöffnerprogr." button on the control device
for 6 seconds to delete all of the assignments from the
control device to the door stations.
The LED starts flashing after 3 seconds. Keep the button
pressed for an additional 3 seconds, until the LED next to
the programming button "Türöffnerprogr." flashes rapidly.
3. Press the "Systemprogr." button on the control device to
exit the programming mode.
Door opener at switching actuator
To delete an existing assignment between the door opener
connected at the switching actuator and the door station, pro-
ceed as follows:
1. Press the "System prog." button on the control device for
3 seconds to start programming mode (see Page 19).
2. Press the "Progr." button on the switching actuator for
6 seconds to delete all of the assignments from the
switching actuator to the door stations.
The LED starts flashing after 3 seconds. Keep the button
pressed for an additional 3 seconds, until the LED next to
the programming button "Türöffnerprogr." flashes rapidly.
3. Press the "Systemprogr." button on the control device to
exit the programming mode.