Assigning several home stations to a floor-call button
If several home stations are to be called simultaneously when
a floor-call button is pressed, a floor-call button can be
assigned to several (max. 3) home stations as follows:
1. Press the "System prog." button on the control device for
3 seconds to start programming mode (see Page 19).
2. Press the floor call button connected to home station 1
for 6 seconds.You will hear a brief acknowledgement tone
after 3 seconds. Hold down the button for another 3 sec-
onds until you hear a long acknowledgement tone.
3. Press the
until you hear a short acknowledgement tone.
3 A successful teach-in is confirmed by a long acknowledge-
ment tone at home station 2.
To assign an additional home station, repeat the procedure
from Step 2.
4. Briefly press the "Systemprogr." button on the control
device to exit the programming mode.
5. Carry out a function test. All assigned home stations ring
when the floor-call button is pressed.
Do not connect floor-call button in parallel
A floor-call button may not be connected to several home
stations in parallel.
button on home station 2 for 3 seconds
29