Button Sewing; Presser Foot: Satin Stitch Foot F - ELNA lotus 2 Instruction Manual

w
q e
4
w
r
q
Button Sewing
q Stitch pattern:
w Thread tension dial: 3 to 7
e Presser foot:
r Feed dog:
Lower the feed dog.
Set the speed control slider at a slower speed.
Match the holes of button to the horizontal slot of the
presser foot and lower the foot to hold the button in place.
Press the stitch width adjusting button q to adjust the
stitch width w so the needle will enter the left hole of the
button.
Turn the handwheel so that the needle will enter the
right hole of the button. Readjust the stitch width if
necessary.
q Stitch width adjusting button
w Stitch width (adjust to span of holes)
Stitch several times.
After you finish sewing, cut the thread but leave 10 cm (4˝)
of threads at the end.
Pull the bobbin thread to draw the top thread to the
reverse side of the fabric and knot the threads.
After the button sewing is completed, raise the feed dogs
for normal sewing.
51
06
Satin stitch foot F
Lowered