Corded Trim; Single Cord For Gathering Heavy Fabric; Fagoting - ELNA lotus 2 Instruction Manual

q w
e
4
q w
e
4
q w
4
e
q
w

Corded Trim

q Stitch pattern:
w Thread tension dial: 3 to 6
e Presser foot:
Sew over three strands of cording to create unique
borders and trims. Pearl cotton, knitting yarn, embroidery
floss, lace thread, fine wool or lily yarn may be used as
cording.
Attach the cording foot H.
Slide the sewing threads to the left and insert three
strands of cording into the slots of H cording foot with
5 cm (2˝) extending behind the foot. Knot together the
strand ends. (The slots on H foot will hold the lengths of
cording while stitches form over them.)
Mark design on the right side of the fabric with a
washable marker.
Stitch slowly and smoothly, turning the fabric as you sew
while guiding the cording over the design lines.
Single Cord For Gathering Heavy Fabric
q Stitch pattern:
w Thread tension dial: 3 to 6
e Presser foot:
Attach the cording foot H.
Insert a single cord in center groove of H foot. Sew over
cord.
Pull cord for desired amount of gathering. Secure ends
and distribute gathers evenly.
Lay gathered fabric over flat fabric and sew the two
fabrics together using straight stitch with stitch length at
3.0 or higher.

Fagoting

q Stitch pattern:
w Thread tension dial: 3 to 6
e Presser foot:
* The stitch patterns 40, 41 and 60 can also be used.
Use these stitches to join two pieces of fabric to create
an open work appearance and add design interest.
Fold under each fabric edge 1.5 cm (5/8˝) and press.
Pin the two edges to paper or tear backing 0.3–0.4 cm
(1/8˝) apart.
Sew slowly, guiding the fabric so the needle catches the
folded edge on each side.
After sewing is finished, tear away the paper.
q 0.3–0.4 cm (1/8˝)
w Paper
58
65
Cording foot H
06
Cording foot H
44
Satin stitch foot F