Table of Contents
Advertisement
q
q
w
r
t
e
w
t
r
e
Button Sewing
q Pattern:
w Presser foot:
e Thread tension:
r Foot pressure:
t Feed dog:
Attaching the button sewing foot T
Make sure to press the lockout key to lock the machine.
Insert the rear pin on the foot into the rear groove of the
foot holder.
q Rear pin
w Rear groove
Gently lower the presser bar while holding the foot with
your fingers.
Press the lockout key to unlock the machine.
Sewing
Lower the feed dog.
Place a button on the fabric and lower the needle into the
left hole of the button by turning the handwheel with your
hand.
Insert the button shank plate under the button.
Lower the foot to hold the button in place, aligning the
direction of the button.
e Button shank plate
Raise the needle by turning the handwheel until the
needle bar swings to the right.
Turn the stitch width adjusting dial so the needle enters
into the right hole of the button.
Start sewing and continue until the machine stops
automatically.
Cut the all threads leaving at least 10 cm (4˝) tails.
Remove the fabric from the machine.
Pass the needle thread at the end of stitching through the
left hole in the button, between the button and fabric.
Pull the needle thread to bring the bobbin thread up to
the right side of the fabric.
r Needle thread at the end
t Bobbin thread
Wind the threads to form a shank and knot them together.
NOTE:
• Do not use the thread cutter key to cut the threads.
Otherwise, you cannot tie the threads.
• The button shank plate cannot be used if the
button is too thick.
67
MODE 2: 032
Button sewing foot T
Button shank plate
3-6
3
Lowered
Advertisement
Chapters
Table of Contents
