Lcd Display; Touch Panel; Arrow Keys; Numeral Keys - ELNA lotus 2 Instruction Manual

q
w
w e q
e r
t
y
u
i
r

LCD Display

NOTE:
Magnetic or electrostatic interference may cause the
LCD display to flicker.
Do not use the machine near appliances that generate
a magnetic field or an electrostatic field such as
microwave ovens.
The LCD display shows following information when the
machine is turned on.
q Identification letter of the recommended foot
w Stitch pattern number
e Stitch width
r Stitch length
Touch Panel
(q and w) Arrow keys
Press " " q or " " w to select the stitch pattern, or turn
the page in the setting mode (refer to pages 12 and 24-26 ).
e Numeral keys
Enter a 2-digit number to select the desired stitch pattern
(refer to page 12).
r Direct pattern selection keys
You can select stitch patterns 00, 06, 12 and 16 directly
by pressing the corresponding direct pattern selection
key (refer to page 12).
t Thread cut memory key
To cut the threads automatically after locking stitches,
press the thread cutter memory key t (refer to page 28).
y Elongation key
Press this key to elongate satin stitch patterns (refer to
page 61).
u Set key
Press this key to enter the machine setting mode for
customizing the machine settings (refer to page 24-26).
i Lockout key
Press this key to lockout the machine when threading the
machine, replacing the accessories etc.
To reduce the risk of injury, all the buttons and keys are
deactivated.
To unlock the machine, press this key again.
11