Auto Thread Cutting; Changing Sewing Direction; Sewing From The Edge Of Thick Fabric - ELNA lotus 2 Instruction Manual

w
q
w
Auto Thread Cutting
To cut the threads automatically after locking stitches,
press the thread cutter memory key.
The thread cutter icon appears on the LCD display.
q Thread cutter memory key
w Thread cutter icon
When buttonhole, tacking, darning or eyelet is selected,
the machine will cut the threads automatically after
sewing is finished.
Press the auto-lock button or reverse button to cut the
threads automatically after locking stitches when other
stitch is selected.
q
NOTE:
Use the thread cutter on the face cover if the thread is
30 or thicker.
Changing Sewing Direction
Stop the machine.
Raise the presser foot.
Pivot the fabric around the needle to change the sewing
direction as desired.
Lower the foot and start sewing in a new direction.
NOTE:
Lower the needle by pressing needle up/down button if
the needle stop position is set at up position.
Sewing from the Edge of Thick Fabric
The black button on the zigzag foot locks the foot in the
horizontal position.
This is helpful when starting sewing from the far edge of
thick fabrics or sewing across a hem.
Lower the needle into the fabric at the point where you
wish to start sewing.
Lower the foot while pushing the black button in. The foot
is locked in the horizontal position to avoid slipping.
The button is released automatically after sewing a few
stitches.
q Black button
w Thick fabrics
28