Download  Print this page

Altering The Buttonhole Width; Altering The Buttonhole Density - ELNA lotus 2 Instruction Manual

Hide thumbs

Advertisement

n
!3
m
,
!4
y
n The buttonhole is sewn in the sequence as shown.
When the buttonhole is finished, the machine will stop
automatically with the needle in the up position.
m Remove the fabric and place a pin just below the
bartack to prevent accidentally cutting the stitches.
Cut the opening with the seam ripper.
!3 Pin
!4 Seam ripper
, When buttonhole sewing is finished, push the
buttonhole lever upward as far as it will go.
y Buttonhole lever
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
After the buttonhole is finished, do not raise the foot or
buttonhole lever, simply start the machine again.
NOTE:
If the fabric is not feeding smoothly when sewing
a double layer buttonhole, increase the buttonhole
density.
Altering the buttonhole width
Press the "
" sign on the stitch width adjusting button to
increase the buttonhole width.
Press the "
" sign on the stitch width adjusting button to
decrease the buttonhole width.
q Stitch width adjusting button
q
NOTE:
The buttonhole width can be adjusted from 2.5 to 7.0.
Altering the buttonhole density
Press the "
" sign on the stitch length adjusting button
to decrease the buttonhole density.
Press the "
" sign on the stitch length adjusting button
to increase the buttonhole density.
q Stitch length adjusting button
q
NOTE:
The buttonhole density can be adjusted from 0.2 to 0.8.
39

Advertisement

Table of Contents

This manual is also suitable for:

Experience 560

Comments to this Manuals

Symbols: 0
Latest comments: