Bobbin Winding; Removing The Bobbin; Setting The Spool - ELNA lotus 2 Instruction Manual

q
w
z
x u
c
u
e
r
y
t
i
y
o
Bobbin Winding
Removing the bobbin
Gently slide the hook cover release button q to the right
and remove the hook cover plate w.
Lift out the bobbin.
q Hook cover release button
w Hook cover plate
e Bobbin
NOTE:
Use the "J" plastic bobbins for horizontal hook (marked
with "J" r). Using other bobbins, such as pre-wound
paper bobbins, may cause stitching problems and/ or
damage to the bobbin holder.
Setting the spool
z Turn the spool thread guide t as illustrated, and the
spool pin y will lift up.
WARNING
Do not lean over the top of spool pin when turning the
spool thread guide. The spool pin pops up and it may
strike your face.
t Spool thread guide
y Spool pin
x Place a spool of thread on the spool pin with the
thread running off counterclockwise.
Draw the thread from the spool about 4˝ (10 cm) of
thread. Attach the large spool holder u.
u Large spool holder
i Slit
NOTE:
If there is a slit i on the spool of thread, be sure to
place the spool with the slit end up.
c Press the spool holder u firmly against the spool of
thread, and then push down the spool pin y to lower
the spool until it is locked in the bottom.
NOTE:
Make sure there is no gap between the spool holder
and spool rim, otherwise the thread can get tangled.
* The small spool holder o is used with narrow or small
spools of thread.
o Small spool holder
NOTE:
If a rimless spool may not let thread out smoothly,
place the spool on the spool pin in up position and do
not use the spool holder so the spool can rotate freely.
18