Darning Stitch; Stitch Pattern: W Thread Tension Dial: 3 To - ELNA lotus 2 Instruction Manual

q w e
4
z x c v
q
e
r
w
t
w
y
u
q
Darning Stitch
q Stitch pattern:
w Thread tension dial: 3 to 6
e Presser foot:
Starting to sew
z Attach the automatic buttonhole foot R and pull the
button holder q all the way out.
Draw the needle thread to the left through the hole of
foot.
q Button holder
x Place the fabric under the foot, and lower the needle
at the starting point w. Then lower the foot.
w Starting point
c Start the machine. The machine will sew locking
stitch, 16 rows of darning, locking stitch again and
stop automatically.
v Turn the fabric and repeat sewing in different direction.
e 2 cm (3/4˝)
r 0.7 cm (9/32˝)
Sewing a shorter darning
To sew a darning shorter than 2 cm (3/4˝), first stop the
machine after sewing the required length y, then press
the reverse button t.
The required length y has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
t Reverse button
y Required length
u Starting point
Sewing a same-sized darning
Simply start the machine to sew another darning at the
same size.
NOTE:
To reset the size of the darning, select the other stitch
pattern and reselect the darning stitch.
Adjusting the evenness of darning
Correct the evenness of the darning as follows:
"d5" is the default setting value.
When the right side of the darn is lower than the left side,
press the " " sign on the stitch length adjusting button q
to set the value to "d6" to "d9", and make the darn even.
When the left side of the darn is lower than the right side,
press the " " sign on the stitch length adjusting button q
to set the value to "d1" to "d4", and make the darn even.
q Stitch length adjusting button
44
23
Automatic buttonhole foot R