Table of Contents
Advertisement
q
e
r
Button Sewing
w
Machine settings
q Stitch pattern:
w Thread tension:
e Presser foot:
r Foot pressure:
t
t Feed dog:
Lower the feed dog.
Set the speed control slider at a slower speed.
Match the holes of button to the horizontal slot on the
presser foot.
Lower the foot to hold the button in place.
Adjust the stitch width so the needle will enter the left
hole of the button.
Turn the handwheel so that the needle will enter the right
hole of the button. Readjust the stitch width if necessary.
Stitch several times.
After you finish sewing, cut the threads but leave 7.5 cm
– 10 cm (3˝–4˝) of threads at the end.
Pull the bobbin threads to bring the needle threads down
to the wrong side of the fabric.
Tie the threads together.
* After the button sewing is completed, raise the feed dog
42
MODE 1:10
AUTO
Satin stitch foot F
5
Lowered
NOTE:
Do not use the thread cutter button to cut the threads.
Otherwise, you cannot tie the threads.
for normal sewing.
Advertisement
Chapters
Table of Contents
