Fcc Radiation Exposure Statement; Industry Canada (Ic) Statement - Motorola RSGu3502 User Manual

FCC and IC Compliance Information
xiv FCC and IC Compliance Information

FCC Radiation Exposure Statement

IMPORTANT NOTE:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To
comply with the FCC RF exposure compliance requirements, the separation distance between the antenna
and any person's body (including hands, wrists, feet and ankles) must be at least 20 cm (8 inches).
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
The availability of some specific channels and/or operational frequency bands are country dependent and are
firmware programmed at the factory to match the intended destinations. The firmware setting is not acces-
sible by the end user.

Industry Canada (IC) Statement

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two
conditions:
1 This device may not cause interference, and
2 This device must accept any interference, including interference that may cause undesired operation of
the device.
This device has been designed to operate with an antenna having a maximum gain of 2dBi. An antenna
having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna imped-
ance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p) is not more than that permitted for successful
communications.