Digital Equipment VAXstation 2000 Hardware Installation Manual page 98

a. You may see a display similar to the following:
KA410-A V2.1
F...E...D...C...B...A...9...8...7...6...5...4...3_..2_..1?
? E 0040 0000.0005
? D 0050 0000.0005
? 6 OOAO 0000.4001
?? 1 OOCO 0000.7004
» >
If the line with the ? E appears, the system time clock has not been
set. When you install the operating system software, you will set the
date and time.
If the line with the ? D appears, the battery charge is low. Once the
system is powered up, it will take about 17 hours for the battery to
recharge.
If the line with the ? 6 appears, the diagnostics do not find a tape
drive installed. If you do not have a tape drive installed, ignore this
message. However, if you do have a tape drive installed, power
down the VAXstation 2000 system unit and review the tape drive
installation steps (refer to Installing the Expansion Box). If you still
have trouble, refer to the VAXstation 2000 Owner's Manual, Chapter
2 (Troubleshooting).
If the line with the ?? 1 appears, the Ethernet module is contained
within the system unit, but the outer Ethernet cable has not been
installed yet. Refer to the Workstations and MicroVAX 2000 Network
Guide, to install the ThinWire Ethernet cable.
If the monitor screen displayed other possible system errors, refer to
the VAXstation 2000 Owner's Manual, Chapter 2 (Troubleshooting).
If the screen displayed only the possible system errors listed above,
proceed to Enter the Test Commands.
VAXstation 2000 Hardware Installation Guide 89