Digital Equipment VAXstation 2000 Hardware Installation Manual page 78

3. Fasten the bail lock connectors on the tape drive cable connector by
pressing them in with your finger (Figure 63).
Figure 63: Fastening the Bail Lock Connectors
4.
5.
BAIL-LOCK
CONNECTOR
TAPE DRIVE
CABLE
Make sure the cable-restraining bar on the rear of the VAXstation 2000
system unit is replaced. If the cable-restraining bar is not replaced, press
it in with your fingers until it locks into place.
Lift up the cable-restraining bar on the expansion box.
VAXstation 2000 Hardware Installation Guide 69